- Home
- Specifications
25 GbE capture, every packet analyzed
IP-Probe is a monitoring appliance with two 25 GbE capture ports and hardware timestamps. It captures every packet at line rate and analyzes hundreds of streams at once. The figures below are measured on live traffic from a separate sender over direct cables.
SFP28 capture ports, also 10 GbE.
On both ports at once, every packet analyzed.
MPTS streams with ETR 290 P1 to P3.
Inputs and capture ports
| Capture ports | 2 x 25 GbE SFP28 (10 GbE or 25 GbE per port), every packet captured |
|---|---|
| Receive modes | pipeline (default): single flows above 1 Mpps, UHD ST 2110-20 or ST 2022-6. rss: more than 10 Mpps of small packets per port. |
| Timestamps | Hardware timestamps on the capture ports; each page shows HW or SW |
| Connection | Switch mirror (SPAN), TAP or aggregation; VLAN-tagged traffic |
| Traffic | IPv4 and IPv6, unicast and multicast UDP and RTP |
| Test input | Built-in signal generator as a virtual input |

Measured performance
Every packet analyzed means that every packet sent was received and analyzed after the 5-second run-in. Measured in October 2026 on the IP-Probe appliance with live traffic from a separate sender.
| Test | Load | Result |
|---|---|---|
| ST 2110 studio traffic, one 25 GbE port | Line rate | Every packet analyzed |
| ST 2022-6, one 25 GbE port | Line rate | Every packet analyzed |
| Two 25 GbE ports at once | Line rate on both | Every packet analyzed |
| Small packets, many flows | Tens of millions of packets per second | Every packet analyzed |
| MPTS streams, all ETR 290 checks | 800+ streams | P1 to P3, every packet analyzed |
ETR 290 cost: +14 ns (11 percent) per TS packet for priorities 1 to 3. When a 25 GbE link comes up with hundreds of streams, packets can be lost for up to 2 s; the run-in period keeps that out of the alarms.
Standards and protocols
What the probe checks per standard. The feature pages describe each check.
| Standard | Coverage |
|---|---|
| SMPTE ST 2110-10 | System timing: media clock of each flow against the grandmaster |
| SMPTE ST 2110-20 | Uncompressed video: identity, RTP loss, TRO, frame analysis, picture |
| SMPTE ST 2110-21 | VRX and CINST compliance, sender type |
| SMPTE ST 2110-22 | JPEG XS video: frames, markers, sizes, picture |
| SMPTE ST 2110-30, AES67 | PCM audio: levels, loudness, listening |
| SMPTE ST 2110-31 | AES3 audio: parity, channel status, Dolby E |
| SMPTE ST 2110-40 | ANC: timecode, CEA-608/708, AFD, SCTE-104 (ST 2010) |
| IEEE 1588 PTPv2, SMPTE ST 2059-2 | Clock analysis and profile check |
| SMPTE ST 2022-6 | SDI over IP: HBRMT header, SDI format, audio, VANC |
| SMPTE ST 2022-7 | Path loss, loss after merge, path differential, receiver class |
| ETSI TR 101 290 | Priority 1, 2 and 3 (except 3.3, 3.9, 3.10) |
| ETSI EN 300 743 | DVB subtitles: display sets, timing, faults |
| CEA-608, CEA-708, OP-47 | Closed captions and captions stopped |
| SMPTE 302M | AES3 pairs in MPEG-TS: PCM, Dolby E, AC-3, E-AC-3 |
| RFC 4445 | MDI delay factor and media loss rate |
| EBU R 128, ATSC A/85, ARIB TR-B32, OP-59 | Loudness targets and limits |
| EBU R 103 | Gamut false color and out-of-gamut check |
| SRT, RIST | Passive connection monitoring |
Video codecs: MPEG-2, H.264, HEVC, JPEG XS. Audio: PCM, MPEG, AAC, AC-3, E-AC-3, Dolby E; AC-4 is listed, not decoded.
The appliance
IP-Probe is delivered as a ready-to-run appliance.
| Form factor | Rack-mount appliance |
|---|---|
| Capture ports | 2 x 25 GbE SFP28 (10 GbE or 25 GbE), hardware timestamps, every packet captured |
| Management ports | Network port for the web interface, REST API and alarms |
| Capacity | 25 GbE line rate on both ports, every packet analyzed; 800+ MPTS streams with ETR 290 P1 to P3 |
Appliance and access
- Linux appliance, works offline; tested on Ubuntu 26.04
- Web interface over HTTPS, works on a phone
- Admin, NOC and Management roles, passkey login
- Software update from the web interface, with checks and go back
- Configuration backup and restore, settings history, audit log
- Network, host name, date and time, power and support bundle from Settings
Integration
- Syslog over UDP, TCP or TLS
- SNMP traps v2c and v3 with the IP-Probe MIB
- Email alarms and digests
- Zabbix template and sender, Nagios check plugin
- Slack, Microsoft Teams and JSON webhooks
- REST API, read-only API keys
- pcapng recordings